MINT1022 22 watt single output series medical - universal input power supply ? 90-264 vac input ? overvoltage and short circuit protection ? compact size, low profle 2.0 x 3.5 x 0.67 ? approved to ul, csa and en standards ? ce compliant (lvd, emc, rohs) ? low standby power loss (<0.5 w) specifcations all specifcations are typical at nominal input, full load at 25c unless otherwise stated sl power electronics corp. ? 6050 king drive ? ventura, ca 93003 ? phone:805.486.4565 ? fax:858.712.2040 ? email:info@slpower.com ? www.slpower.com international safety standard approvals output power natural convection 22 watts continuous, 24 w peak for 60 sec - onds, 10% duty cycle minimum load not required total regulation (line and load) 1.5%, see table rise time at turn-on 100 ms max. transient response 50% step load, 0.2a/s 4% max. dev., 1.5 msec max. recovery to 0.5% temperature coeffcient +/-0.03%/ c typical overvoltage protection standard - see chart voltage adjustability factory set with fxed resistors to maximize reliability output specifcations voltage universal input 90-240vac (nominal 100-240vac) frequency 47-63hz input surge current thermistor limited 32a max. earth leakage current 264v, 60hz 125 a max. (200 a single fault) input current 120vac 0.45a 230vac 0.25a input fuse f1 2.0 a input specifcations thermal performance operating ambient 0-70 c (see ratings chart) non-operating -40 to +85 c 0-50 c full load. see table. 50-70 c ambient derate to 50% relative humidity non-condensing 0-95% rh maximum altitude operating 10,000 ft./40,000 ft. max. /non-operating vibration 5hz-500hz 2.5 g rms shock per mil-std-810e 516.4 part iv environmental specifcations hold-up time 120vac, 60hz 15ms min. at 22w output effciency 120vac, 22w output 70-80% typical depending on output voltage switching frequency fixed 15 to 100khz, varies with line and load safety approvals medical ul/en/iec 60601-1 csa22.2 no.601 maximum weight 100 grams (0.20 lbs) mtbf 25 c, ground benign, 300,000 hours telcordia overload and short fully protected cycling type power limit circuit protection general specifcations
MINT1022 22 watt single output series medical - universal input power supply medical voltage output total initial setpoint ripple/ ovp model output current regulation tolerance noise setpoint MINT1022a0505i01 5v 4.40a +/-1.5% +/-2.5% 100mv 6.2+/-0.6v MINT1022a1205i01 12v 1.83a +/-1.5% +/-2.5% 120mv 14.1+/-1.1v MINT1022a2405i01 24v 0.92a +/-1.5% +/-2.5% 240mv 28+/-2.5v m i n t 1 022 a 05 05 i 01 medical internal standard factory no. of output initial design output output input standard product designation outputs wattage of the product voltage connector connector confguration condor part number key emc information conducted emissions en55011 level b radiated emissions en55011 level b line freq. harmonics en61000-3-2 complies voltage fuctuations en61000-3-3 complies esd contact en61000-4-2 6 kv contact esd air en61000-4-2 8 kv air radiated immunity en61000-4-3 3 v/m fast transients (eft) en61000-4-4 2 kv/5 khz line surge immunity en61000-4-5 1 kv diff /2 kv common mode conducted immunity en61000-4-6 3 vrms power freq. mag. feld en61000-4-8 3 a/m voltage dip immunity en61000-4-11 consult factory general specifcations (continued from p. 1) notes 1. other output voltages available by special order 2. regulation from initial setpoint for 50% load change from 50% to 0% or 100% 3. peak output rating is 24 watts for 1 minute 4. 20mhz bandwidth scope, differential mode. measured with scope probe directly across output terminals of the power supply with load terminated with 0.1 f 5. heatsink temperatures should not be allowed to exceed 90 c 6. installation data is online at www.slpower.com input j1 molex 22-43-8040 input j1 molex 22-43-8040 pin 1 ac line pin 4 ac neutral ground solder hole on board output j2 molex 22-43-8040 pin 1 output 1 pin 2 output 1 pin 3 common pin 4 common mating connector (molex) input housing 50-37-5043 contacts 08-70-1040 output housing 50-37-5043 contacts 08-70-1040 mechanical notes sl power electronics corp ? 6050 king drive ? ventura, ca 93003 ? phone:805.486.4565 ? fax:805.487.8911 ? email:info@slpower.com ? www.slpower.com data sheet ? 2008 sl power electronics corp. the information and specifcations contained in this data sheet are believed to be correct at time of publication. however, sl power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. specifcations are subject to change without notice. rev.9/08/08
|
